3. Equipment

Equipment includes warp creels and suspensions for two-dimensional reinforcing materials, impregnating units with a variety of auxiliary impregnating equipment, guide elements to feed the reinforcements into the pultrusion moulds, as well as a variety of take-off elements and sawing devices. Specific technical know-how with regard to individual plants is reflected in the respective equipment design and lay-out.

Several of these plants are charted below. Yet there are comparatively few plants being offered; most of the plants used in this context were constructed by the respective profile manufacturers themselves.

PULTRUSION UNITS – MOULDS

Pultrusion moulds made of high-alloy steels are approximately 0.75 to 1.5 m long; their width and height correspond to the profile cross-sections and are subdivided into several sections. The interior is frequently polished and chrome plated in order to ensure low frictional resistance and good surface quality.

PULTRUSION

1. Introduction / Historical background

2. Technical principles

3. Equipment

4. Raw materials

5. Design parameters

6. Properties

7. Flammability ratings

8. Standardisation

9. Fabrication

PUBLICATIONS

Download our publications

FOLLOW US ON

SOCIAL NETWORKS